Bench Clamp
Used to clamp the MT-10 Tool Stand base to table tops. This handy unit eliminates hole drilling and secures the tool stand in place. It’s flexible and ready to move at moments notice.
Model: 311
Item # 180035
A rugged adjustable tool support stand. Prevent tool damage due to dropping or mishandling. Convenient tool positioning - adjust both vertically and horizontally. Electric tool cords can be tie-wrapped to the vertical base to keep work station clean. 360 degree swivel. Four
feet high and maximum arm length 1 3/4 feet. A balancer is recommended.
Model: MT-10
Item # 060050
Pneumatic Center Block - Fitted with a pre-tapped plumbing holes. For attaching air fittings or air hose on MT-10 tool stand
Item # 061385
