Certified

Supplied with NIST-Traceable
Certification of Calibration

Standard accessories include:
Six Screw Run Down Adapters
Universal Charger
RS-232 Cable
1/4” Female/Hex Square Drive Adapter
Mountz Data Acquisition Software
Case

Accuracy ± 0.5% of reading from 20% to 100%
Accuracy ± 1% of reading from 10% to 20%.

Recommended for all small hand tools & non-impacting power tools.

Features a built-in transducer and graphic display.

Selection of two operation modes: (Track, Peak).

Four units of torque measurement available:
(lbf.in, cN.m, N.m, kgf.cm.)

Switchable 110V and 220V.

Four digit display.

Torque Ranges

* EZ-TorQ features a 17mm 6pt Hex Socket. The unit includes a 1/4 Female Hex Square Drive Adapter that slides into the socket.

Calibration Test Equipment:
For Torque Analyzers & Torque Sensors.
 

Calibration Hex Step Adapter: Allows multiple size wrenches to be used with one adapter.

Note!
Since a tester cannot always duplicate actual joint characteristic, the torque reading displayed on the EZ-TorQ may vary from the actual torque that a tool will apply to a joint. A run down adapter that simulates a variety of different joint characteristics is provided with the EZ-TorQ. When critical assemblies are involved, the torque output of the power tool being used should be verified on the actual assembly using a calibrated measuring torque tool.

Aura
(Auto Revering Run Down Adapters)
Once the tool shuts off, the AURA automatically unwinds for the next run down. Eliminates the need to back it out.

Torque Analyzer operational in: English, Spanish, French, German, Italian and Chinese.

Selectable filters to eliminate unwanted “noise” :
(500Hz, 1000Hz, 1500Hz, 3000Hz).

RS-232 interface to download readings in "real time."

"Flash" memory allows upgrades to be done by the user or via the internet.

Includes three PC Windows based software programs:
  EZ Terminal - for updating firmware, selecting torque direction and
             changing languages.
  EZ Calibration - for multipoint calibrations.
  Data Acquisition -collecting and analyzing data with Microsoft Excel®.

Includes screw type Run Down Adapters and a selection of both American and Metric screws along with washers to allow close simulation of actual joints.

Two methods of calibration are provided, a single point calibration (using a manual pot adjustment) and a multipoint calibration using EZ Calibration software.