Call Us: 1-866-404-2475

Making a Safer World Through Accuracy and Precision

Case Studies

The Mountz Weld Stud Test Tool is designed for use during the production of sheet metal products to test the strength and integrity of welds used to attach threaded studs to the sheet metal.
Looking to eliminate the lost production time and the cost of sending the torque tools out for calibration service, manufacturer searches for a cost effective method for in house calibration and documentation of calibration records for traceability...
An electronics manufacturing company uses the PTT to audit their 150+ pneumatic tools on a daily basis. Each tool is bar-coded and a unique tool test is created for each tool.
Medical Manufacturer needed to develop a process that would assure system installation contractors could tighten large bolts on a 4000 lb rotating counterweight to a torque specification of 750 lbf ft.
A Canadian rail yard selects Mountz electric torque multiplier to help raise and lower decks during the loading of automobiles into rail cars.
An industrial gas engine manufacturer increased their production time and eliminated the costly engine rework associated with their old process by selecting the CLD torque multiplier.
Deep down in a coal mine, the foreman faced  lengthy and costly dilemmas for two key maintenance applications. The first maintenance application was for removing and re-tightening the bolts during the servicing process for "Mining Heads" used...
Deep down in a coal mine, the foreman faced  lengthy and costly dilemmas for two key maintenance applications. The first maintenance application was for removing and re-tightening the bolts during the servicing process for "Mining Heads" used...
A helicopter manufacturer had a critical torque application during the routine maintenance process of their aircraft. The rotor of the helicopter requires servicing after every 20 hours of flight. Some of these aircraft are serviced in very remote...
The Mountz torque multipliers were used in the maintenance process of opening and closing the two large valves daily. Overtime, the plant manager saw the maintenance frequency and costs for servicing the tools decline.